Digital PH EC TDS Meter Tester Temperature Pen Water Purity PPM Filter Hydroponic for Aquarium Pool Water Monitor 0-14 PH 0-9990 harbor freight tape measure Measurement & Analysis Tools

Brand Name:	milaike
Certification:	CE
Origin:	CN(Origin)
With Backlight Or Not:	No
Is Smart Device:	No
Model Number:	TDS EC TEMP PPM Tester
Display Type:	DIGITAL
Battery:	No
Calibration powder:	yes
Type:	Portable PH meter
Measuring Range:	0.00~14.00
Operating Temperature:	0~60°C
Resolution:	0.01
Accuracy:	0.01
Weight:	50g
For:	Fish tank Swimming pool
Fit for:	Industry And Agriculture
name:	Conductivity measurement

PH Meter

Product Parameters:

Measuring range: 0.00-14.00PH

Accuracy error: ±0.01PH

Resolution: 0.01PH

Working temperature: 0℃-60℃

Calibration method: 2-point automatic identification calibration, support 1-point or 2-point or 3-point calibration

1 point: 6.86

2 points: 6.86+4.00/6.86+9.18

3 points: 4.00+6.86+9.18

Electrode: glass bulb

Temperature compensation: ATC automatic temperature compensation

Battery: 2X1.5V (LR44 button battery)

(ot included)

3pcs

Buffer Powder

(Included)

Dimensions: 155mm×31mm(W)×18mm(H)

Weight: 50g

Steps:

1. Remove the protective cover.

2. Clean the electrode of the pH meter first. And wipe the electrode dry with filter paper.

3. Turn on the switch located on the battery compartment.

4. Insert the pH meter into the liquid until the liquid is immersed in the "immersion line", so that the solution can be immersed slightly above the "immersion line".

5. Stir the solution gently and wait for about two minutes. Read the displayed value.

6. Finished use. Clean the electrode. Turn off the switch. Put on a protective cover.

Note:

Please note that the PH pen probe is a glass product, which is fragile. Please do not bump it with anything. Once it is damaged, it cannot be replaced. Be sure to protect the probe. Use absorbent paper to gently absorb the water on the probe. .

Battery:

If the backlight brightness drops significantly or the displayed value is blurred, the battery should be replaced.

When replacing the battery, pull out the battery compartment to replace it.

Pay attention to the positive and negative terminals of the battery.

Package Included:

1pcs pH Meter

3pcs Buffer Powder

Battery

(NO)

EC Meter

Product Parameters:

3 in 1 Digital TDS meter can provide accurate readings of TDS EC and temperature.

TDS instrument has automatic temperature compensation in measurement mode.

5 minutes automatic shutdown. Save power and extend battery life.

Multi mode conversion: there are 4 different modes for TDS EC instrument. Press shift to switch between different modes.

Mode memory function. Each startup mode is the default mode used before shutdown.

TDS water meter is a professional water level tester with simple operation, fashionable appearance and small volume.

It is very suitable for all water quality testing, water purification applications, wastewater regulation, aquaculture, hydroponics, laboratory and scientific testing, pool, ecological testing, colloidal silver, water treatment, etc.

Specifications:

Measurement range: conductivity: 0-9990 μ s / cm

TDS:0-9999ppm

Temperature range: 0.1-80.0℃(32.0-176.0℉)

Accuracy: ± 2%

Material: ABS

Size: 154 * 30 * 14mm/6.06*1.18*0.55"

Batttery:1 PC 3V CR2032 battery

(Not included!!!)

Package Included:

1pc EC Meter

Battery

(NO)

TDS Meter

Product Parameters:

Hold function: Saves measurements for convenient readign and recording

Auto-off function: Turns off meter after 10 minutes of non-use to conserve batteries.

Measurement Range: 0-9999 ppm (When the measured value exceeds 999 ppm, please make the display value x10)

Specification:

Item Type: TDS Water Meter

Material: Plastic

Measurement Range: 0-9999 ppm

Accuracy: +/-2%

Temperature Range: 0-50 celsius

Battery: 2xLR44 batteries, 1.5V

(NOT Included )

Size: 155x31x23 mm

Application:

Check the performance of your water filter.

Check for nardness (1 grain = 17ppm).

Make sure you always drink pure water!

Please refer below standard for testing water:

0-50 ppm --------- High Purity Water

50-100 ppm ------- Pure Water

100-300 ppm ------ General Pure Water

300-600 ppm ------ Fouling

600-1000 ppm ----- Poor Taste Water,Fouling

Above 1000 ppm --- The water is not suitable for drinking

Package Included:

1pc TDS Meter

Battery

(NO)

Customized Content:

The appearance, color, printed logo of the product can all be customized.

The product packaging box can be customized, such as: paper outer box, plastic case, leather case, etc.

Customization Process:

Step 1: Consult customer service and confirm that you need to customize the content.

Step 2: Free design, according to your needs, professional design team, free design for you.

Step 3: After making the sample, confirm the product effect with you.

Step 4: Factory processing and production.

Step 5: Pack carefully and ship it.

High Accuracy 0.1 LCD Digital PH Meter Tester for Water Food Aquarium Pool Hydroponics Pocket Size PH Tester With Screwdriver

USD 2.24/piece

3 in 1 Digital LCD TDS EC Meter Pen for Water Tester Aquarium Pool Automatic Calibration Thermometer Water Quality Purity Test

USD 1.45/piece

PH Meter 0.01 PH High Precision Water Quality Tester with 0-14 PH Measurement Range, Suitable for Aquarium, Swimming Pool

USD 3.69/piece

12V-84V Lead Acid Battery Capacity Indicator 36V 48V Battery Charger Detector Car Motorcycle Voltmeter Voltage Gauge Test

USD 3.08/piece

USB 5V 2.4A Car Voltmeter Voltage Meter Panel 12V-24V 3S-7S Lithium Battery Capacity Indicator Power Tester Li-ion Lead acid

USD 1.88/piece